article no.: 30307

20 Adern used continuous pickling line

STAKU

Description

HCL continuous wire pickling line, 20-strand

The system works according to the flood tank principle, i.e. a lower tank for storing the medium with built-in pumps and the flood tank above for wire treatment. The flood tank is closed with flaps above it. The flood tank is divided into 2×10 wires by a centre bar. Each side of the flood tray can be filled separately.
Wire treatment:
The wire passes through the flood tank over a distance of approx. 8 metres, whereby the wire surface is pickled.
The vapours and gases resulting from the bath temperatures must be fed into an extraction filter system on site. The vapours are extracted through an extraction duct attached to the rear, which is installed on the on-site extraction system.

Wire running direction: from right to left (operator side)
Wire diameter: 3.5 mm
Wire speed: 45 to 55 m/min
Number of wires: 2×10 wires
Wire running height: 800mm
Wire field pitch: 40mm
Wire inlet: ceramic guide bushes
Wire guide: slotted granite guide stones
Bath temperature: max. 50 °C
Bath heating: heat exchanger (Calorplast)
Bath volume: approx. 5200 litres
Flood tray volume: approx. 700 litres
Flood tank filling: approx. 3min
Installed electrical power: approx. 0.5kW (400V, 50Hz)

producer: STAKU
type designation:
condition: used
Length 10000 mm
Width 1800 mm
Height 2300 mm
Material PP 30 mm (system housing)

chemical proceeding